zonxzonz ae View my complete profile

Standing sysco motors or wheelie can be done by raising the engine rotation suddenly so that the rear tire would spin faster and front motorcycle tire will lift by itself. sysco Given a huge risk if you lift the front tires of motor (standing or wheelie), then you should do this in a safe, quiet and away from the bikers or other cars. Never you do this on the highway, because it certainly will endanger yourself and especially for the people around you. Before doing standing, you are advised to prepare your bike in maximum condition. In addition, you must be prepared to accept the risk if the motor mounts you have things you do not want. Use standard also supplies complete drive as standard helmets, thick pants and jackets so that you avoid injury if you fail to do standing. As a precaution, make sure you do this standing under the supervision of your friends, so that in case of unwanted things to you, your friend can give first aid to you. Standing ways of Current Motor Stop 1. Make sure the fuel is not full so that the motor load is not too big and easy to maintain balance, make sure the gear is in neutral, then pull the front brake lever. 2. You should sit in the rear seat position to make it easier to maintain balance. 3. Put gear to gear 1, then hold and is not released in advance or press the clutch (for manual transmission motors). 4. Pull the gas lever slowly, so RPM to approximately 6,000, loose teeth and so the front tires lift motors do not forget to play the gas so that the motor remains in a state of standing. 5. If on your bike there is no display to show RPM, you can estimate it by the sound of your motor engine rotation, to experiment sysco you can start from a low first round, repeat until you get a proper estimate sysco rounds to do standing. 6. If the front tire motorcycle has raised high enough, then hold down the gas and do not pull on the gas lever again. 7. To be able to get down safely, stepped on the brake pedal back little by little and do not jump to step on the brake pedal runs to avoid you and your bike fell. 8. Slide the handlebar down slowly. How to Standing At Motor Drove 1. When you start driving the motor, run the motor at low speed and not too high. 2. Enter resistant sysco teeth and hold, or press the clutch (for manual transmission motors) then pull the lever of gas to approximately reach about 6000-8000 RPM. 3. Remove sysco the front of the motor gear and tires will be raised. But need I remind you once again, too often can damage the standing of the motorcycle front shock absorber. In addition, the chain and the engine will be more easily damaged due to engine speed suddenly forced sysco to be high. and certainly fuel would be wasteful because it is used to generate a large force. Thankyou good luck!
zonxzonz ae View my complete profile